Roof Repair
The failed section is found, traced and rebuilt, so the rest of the covering can stay on for years.
Triple-decker roofs, low-slope decks and coastal wind damage, handled from the first call through to a written scope. Phones are answered around the clock.
Fastest: call (833) 751-2102. Or send this and we call you back.
Local weather drives activity here: heat, humidity and rain change what shows up week to week.
New Bedford Roofing takes roof calls for New Bedford and the South Coast towns around it. Leaks at flashing, wind lift after a bay storm, ice at the eave and planned replacements on old houses are the usual reasons people call. Describe what you can see and the visit is planned from there.
New Bedford is an old city of tall, close-built houses. Much of its housing predates the Second World War, and the triple-decker is the common form: three stories of wall under a roof that is often flat or low-slope at the top. Those houses leak in predictable places and they are harder to reach than a suburban gable.
The weather comes off the water. The hurricane barrier at the mouth of the Acushnet River closes for high tides and coastal storms, but it holds back surge, not wind or snow. Hurricane Bob in 1991 brought sustained winds of 75 to 100 mph across most of southeastern Massachusetts, and the roofs on this coast still carry that history.
Pick a service for symptoms, process and typical cost, or call and describe what you hear and see.
The failed section is found, traced and rebuilt, so the rest of the covering can stay on for years.
The old covering comes off to the deck, the deck is checked, and the new roof is built on sound wood.
The roof is taken off and rebuilt with the building still in use, which changes the order of every step.
Water on a flat roof sits and finds the weakest seam, so the repair starts with drainage and every joint.
Wind works at the edges first, so the repair starts with the rake, the ridge and the eave, then moves inward.
A post-storm inspection checks what the wind and water did, records it, and says what can wait and what cannot.
A secured tarp keeps rain off an open roof for the time it takes to schedule the real repair.
The leak is traced to its entry point, the flashing that failed is rebuilt, and the joint is tested before the crew leaves.
The metal that seals the chimney to the roof is rebuilt, and the mortar it sits in is checked where it has opened.
Asphalt shingle is the common covering on the city's houses, and a sound replacement starts with the deck it sits on.
Shake and slate are repaired piece by piece, so the work protects the sound material rather than replacing it.
Metal sheds wind and snow well, and its life near the bay depends on the fasteners, the finish and the edge detail.
Ice at the eave backs water under the shingles, so the job is to clear the blockage safely and find the leak it caused.
Air moving through the attic keeps the roof boards dry and cold, and it protects the shingles and the snow line.
A gutter that fails sends water onto the fascia, the wall and sometimes the neighbor's lot, so the repair follows the water.
The skylight is a joint in the roof, and its leak is usually at the flashing around it rather than in the glass.
A written report records the roof's condition with photographs, so the owner, a buyer or a landlord can act on the facts.
A seasonal check after each bay storm catches small wind damage before it becomes a leak.
A ceiling stain is usually a symptom. The attic shows where the water entered, and the visit starts there rather than at the mark on the plaster.
Findings are dated and photographed, and the homeowner sees them before any work is agreed.
A visit to a three-story house plans the route to the roof, the staging and the rear porch before anyone climbs.
Flat and low-slope sections are measured, drained and sealed as their own surface, not left as an afterthought to the shingles.
The towns from Fairhaven and Acushnet to Westport, Mattapoisett and Fall River are covered, and the building department for each address is named when a permit question arises.
A call at night or on a weekend is answered, and the visit is set for the first available time once the details are in.
A stain, a loose tab, an icicle line or a chimney that has moved is enough to start. Note the date you first saw it.
The route to the roof, the access and any staging are worked out from the details before the crew is sent.
The attic, the covering, the flashing and the drains are each checked, and the source of the water is traced to its entry point.
Nothing is ordered until the scope is written down, dated and agreed by the homeowner.
Water often enters during a storm and shows inside only after it has traveled along the framing for days.
A drip at a wall junction or a chimney can run down a rafter or along the top of a plate before it reaches a ceiling. The stain then appears in a room that has no obvious connection to the entry point, which is why the attic has to be read before the plaster is touched.
Triple-deckers make the trail longer. Water that enters at the top floor can reach the ceiling of a lower unit, and the owners of each unit may see a different symptom from the same cause. A single visit that reads the whole house is more useful than a patch on the lowest stain.
Ice builds at the eave where heat from the attic melts snow and the water refreezes behind it.
Snow on a warm roof melts from below, and the meltwater runs to the eave, where it freezes and builds a ridge. Water that melts higher up then pools behind the ridge and works under the covering. The damage shows as a stain on the top floor and a wet wall beneath it.
The fix is usually a mix of attic ventilation, insulation pulled back from the eave, clear gutters and, where the roof calls for it, a membrane under the covering at the edge. A roofer should explain which of these the house needs rather than sell one of them as a cure.
Wind lifts the edge of the covering first, then finds the nails and sealant that let go.
Open water gives wind a long run, so a shore roof takes gusts at close to full strength. The eave, the rake edges and the ridge carry the greatest uplift, and a single lifted row can open a path for rain to the deck beneath.
After a bay storm, check all four sides, because a gale that turns can load a side that has been sheltered for years. A lifted tab that is reset early costs far less in time than a stained ceiling that has to be traced later.
The roof is measured, the layers are counted and the deck is judged before a scope is written.
A replacement starts with a measurement of the roof area, the pitch and the number of planes, and with a count of the coverings already on the deck. Those figures set the tear-off and the disposal, and they are recorded on a sketch the homeowner can keep.
The deck is judged once the covering is open, and a stated allowance covers any soft boards found beneath it. The scope then names the counted details, the staging and the permit question, so that every line can be checked against the house.
ZIP 02740, 02741, 02742, 02744, 02745, 02746
ZIP 02719
ZIP 02747
ZIP 02748
ZIP 02743
ZIP 02739
ZIP 02790
ZIP 02791
ZIP 02717
ZIP 02702
ZIP 02770
ZIP 02738
ZIP 02720, 02721, 02723, 02724
ZIP 02725, 02726
ZIP 02571
ZIP 02576
ZIP 02347, 02348
ZIP 02779
ZIP 02837
New Bedford, MA · 28 km service radiusCall (833) 751-2102
We also cover many smaller communities across Bristol County. Check your ZIP.
Call any hour and explain what is going on. You get a clear price before any work starts.
This guide prints no dollar figure, because no verified New Bedford or Massachusetts price was found, and a national average says little about a city of old, tall houses.
The barrier across the Acushnet River closes for high tides and coastal storms, and it protects low ground from surge.
A triple-decker is three stories of wall under a roof that is often flat, low-slope or hidden behind a parapet, with a rear ell and porch roofs beside it.
Urgent leaks are planned for the first available slot, and planned work is booked once the details are in. The timing depends on the weather and the day's schedule, and the call will tell you what to expect.
Photograph it, note the date and place a bucket or a towel beneath it. Do not seal a joint yourself, because the source is often somewhere else along the framing.
The company that attends the house plans access and notice around the occupied units. Tell the company about the tenants on the first call so the plan is made before the crew is sent.
It should be. The attic beneath the problem is where the entry point is most often found, and the findings are photographed and written up before a scope is agreed.
That depends on the town and on the work. Permits are issued town by town, and the building department of the town where the house stands answers the question for that address.
Ask for its Massachusetts home improvement contractor registration number and check it with the state before signing. Ask who is attending and what registration or licensing applies to the job.